...AUTOMOTIVE PASSENGER CAR SYNCHRONOUS BELT DRIVE SYSTEM Technical Service Bulletin TIMING BELT SETUP FOR 1999-2012 SAAB AND SUBARU 2.0L/2.2L/2.5L APPLICATIONS WITH MANUAL TRANSMISSION Industry concern has been raised regarding the Subaru hydraulic tensioner (Gates T43138) applications li...
...AUTOMOTIVE PASSENGER CAR ACCESSORY BELT DRIVE SYSTEM Technical Service Bulletin ACCESSORY BELT DRIVE SYSTEM HONDA BULLETIN PA010-12› PART NUMBER: 38332› MAKE: Honda› MODEL: Accord Odyssey Pilot Ridge line› YEAR: 2003-2007› ENGINE: 3.0L 3.5LWith over 100 years of experience,...
...BACrank A.C.W.P.Alt.Break-in Procedure: Recommended drive cycle is no less than 20 minutes before checking and setting final drive tension. ACCESSORY BELT DRIVE NOISEThe Original Equipment Manufacturer has identified a possible accessory drive belt squeal on some 2007 Toyota Yaris vehicles...
...Timing belt drive systems come with a variety of tensioning methods and components. In the past, engines used a manual tensioner (or eccentric pulley) for the drives, which had to be installed and then locked in place. Over time the belt tension would change as there is no self-adjustment...
...AUTOMOTIVE PASSENGER CAR ACCESSORY BELT DRIVE SYSTEM Tech Tip The two part numbers seen on the image below come on every belt sleeve. These numbers give important data with regards to the “effective” length of the belt. The effective length is a measurement of the entire length of the...
...AUTOMOTIVE PASSENGER CAR COOLING SYSTEM Tech TipF lushing:Over time, coolant in the cooling system can break down resulting in the need to service the system. The protectants in many of today's coolants become depleted and weak leading to corrosion, rust and scale. When this depletion tak...
...Symptoms:Water pump has missing or broken teeth, or sprocket falls off the shaft.Probable cause of failure:Misalignment or damage of the tensioner, guide or chain.Corrective action:Visual inspection is required to verify the correct alignment of chain tensioner and guide. Inspect for broke...
...BULLETIN TT003-15› MAKE: All makes with a serpentine belt› MODEL: All models with a serpentine belt› YEAR: All years with a serpentine belt› ENGINE: All engines with a serpentine belt PULLEY ALIGNMENT & TENSIONToda...
...To ensure optimal operation of newly installed belts, the CVT sheaves must be cleaned of all old belt residue, glazing, and oils. Cleaning can be accomplished by carefully scuffing belt contaminates off the sheave/belt contact area with a mild abrasive such as 220-400grit sandpaper, Scotch...
...Unbeknownst to many, automatic belt tensioners are actually a wear item, and therefore cannot be classified as a prototypical hard part. Internal components in the tensioner can fail, causing stress on the belt and other accessory components. A tensioner is a relatively inexpensive part to...