menu

Search 4,455 docs, articles & videos from the world’s leading Automotive part manufacturers

  

180 results found for Pierburg

...1Feeler gauge0.12PreparationInspectionFirst, clean the pistons thoroughly and remove all traces of oil carbon from the ring grooves. Remove the carbon from the oil return bores using a twist drill and tap wrench; clean the grooves without damaging the groove sides. Replace cracked, collaps...

...Completion of new cylinder heads (OHV engines)Checking the componentsPreparationDe-wax and wash new cylinder heads and check for external damage. Clean oil bores and valve guides with a brush. Note:Carefully clean the mounting par ts to be re-used and replace any defective used par ts.Chec...

...ACDBFuel supplyDiagnostic trouble code Displayed faultPossible causesP0170 Fuel mixture, cylinder line 1 – malfunctionLeakage on intake sideFuel pressureInjection valvesInjection nozzlesHeated lambda sensorActivated carbon filter solenoid valveBlowing in of secondary airFuel pump Possibl...

...Oil consumption caused by:Distortion of cylinder bores Distor tion of cylinder bores is easy to identif y from individual, bright areas on the cylinder sliding sur face. As a result, piston rings are not able to reliably seal distor ted or deformed cylinder bores to prevent the ingress of...

...Installation and adjustment errorsIncorrect valve clearance settingsCause: The valve clearance has been set too tight or the maintenance intervals have been exceeded.Consequence: The value no longer closes properly. Combustion gases flow past the valve seat and heat up the valve head. This...

...Information on the product range can be found in our catalogue "Engine Bearings".Or ask your local Motorservice partner. We have also provided a lot more information for you at www.ms-motorservice.com and on our Technipedia at www.technipedia.info.Engine bearingsHandling and funct...

...Repair shaft sliding surfaces quickly and simplyShaf t protection sleeves offer a cost-effective alternative to replacement or time-consuming remachining of the broken-in or worn shaf ts. The shaf t protection sleeve is slid easily over the worn sliding surface of the shaf t. This is of te...

...Preparation• Prehoning: grain size 150 (material removal of approx. 0.06 mm based on diameter)• Finish honing: grain size 280 (material removal 0.02 mm based on diameter)• Plateauhoning:grainsize400–600(removeprofilepeaks inafewstro...

...Piston ringsFunction and designMaintenance faultsDirt in the intake airDir t that reaches the combustion chamber settles in the ring grooves where it causes abrasive wear in the ring grooves and at the piston ring flanks. This results in excessive ring height clearance and consequently to...

...SI 1680 For technical personnel only! Page 1/1 Correct storage of cylinder liners and assemblies Cylinder liners are deformed by compressive forces on the sides. Cylinder liners must therefore never be packaged and/or stored horizontally. To prevent deformations, cylinder lin...



1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 ...[Next 10 of 18 pages] ...