menu

Search 4,469 docs, articles & videos from the world’s leading Automotive part manufacturers

  

180 results found for Pierburg

...© MS Motor Service International GmbH – 03/11 ENwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyKolbenschmidt Pierburg grouPSI 1001Fig. 1: cylinder head with installed swirl chamber insertsThe right of changes and deviating pictures is reserve...

...Oil consumption caused by:Distortion of cylinder bores Distor tion of cylinder bores is easy to identif y from individual, bright areas on the cylinder sliding sur face. As a result, piston rings are not able to reliably seal distor ted or deformed cylinder bores to prevent the ingress of...

...Swirl flaps and Tumble flaps PIERBURG manifolds, as used in modern Otto- and diesel vehicles, often have swirl or tumble ȯ aps in their inlet ports. Swirl fl aps Swirl ȯ aps produce a swirl alongside the cylinder axle. They are used in diesel vehicles to improve the mixing of t...

...1Feeler gauge0.12PreparationInspectionFirst, clean the pistons thoroughly and remove all traces of oil carbon from the ring grooves. Remove the carbon from the oil return bores using a twist drill and tap wrench; clean the grooves without damaging the groove sides. Replace cracked, collaps...

...© MS Motor Service International GmbH – 01/12 ENPI 1051PRODUCT INFORMATIONwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyKSPG Automotive GroupVehicles: Product: air mass sensor LMS4BMW, models with diesel / turbo diesel engine PIERBURG No. Ref...

...Completion of new cylinder heads (OHV engines)Checking the componentsPreparationDe-wax and wash new cylinder heads and check for external damage. Clean oil bores and valve guides with a brush. Note:Carefully clean the mounting par ts to be re-used and replace any defective used par ts.Chec...

...Pierburg TechTip Exhaust Gas Recirculation - an overview Exhaust Gas Recirculation (EGR) has proven to be a successful method of emission control. With high pressure EGR, exhaust gas is removed, immediately after the cylinder and mixed with the intake air. Low-pressure EGR is now c...

...© MS Motor Service International GmbH – 0208 ENwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyKolbenschmidt Pierburg grou PS E R V I C EIN f o r Ma t Io NSI 0095 Vehicle Product: Regulating throttleAudi A3 2.0 TDI PIERBURG No.7.14393.26.0Repla...

...Repair shaft sliding surfaces quickly and simplyShaf t protection sleeves offer a cost-effective alternative to replacement or time-consuming remachining of the broken-in or worn shaf ts. The shaf t protection sleeve is slid easily over the worn sliding surface of the shaf t. This is of te...

...SI 1210For technical personnel only!www.ms-motorservice.com© MS Motorservice International GmbH – A Rheinmetall Company – 04/15 ENPage 1/2Tips and tricks ... …for correct installation and long service life of the new short block• Please note that cylinder heads which may be in...



4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13
footerlogo
popup