menu

Search 3,742 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3024 PDF Files Listed

...Citroen C6: Increased engine idle speed Question: We are having trouble diagnosing a fault on a 2007 Citroen C6 2.7 HDi with an increased engine idle speed. The vehicle came in with the engine malfunction indicator lamp (MIL) illuminated and several engine management trouble codes stored....

  • img
  • Type

    Installation Instructions

  • LuK Clutch Academy Peugeot 508 SW
  • Apr 19

  • LuK (102) Contact
  • PDF

...LuK Clutch Academy REPXPERT's Alistair Mason replaced the clutch and dual mass flywheel in a Peugeot 508 SW fitted with a 1.6 HDi engine, which had covered more than 170,000 miles. On initial inspection, the gearbox looked difficult to access and even harder to remove; however, by detach...

  • img
  • Type

    Tech Tip

  • Engine management - Past and future - Frank Massey
  • Apr 19

  • Autoinform (109) Contact
  • PDF

...Engine management - Past and futureI have long accepted that nothing stands still for long in this industry. Just when you think you have a grasp of the subject, something is sure to upset it. Nothing illustrates this more than power train diagnostics. Initially called fuel injection, late...

...Toyota Multi-Mode transmission (MMT) clutch replacement The Toyota Multimode transmission has been fitted to various models, including the Aygo, Yaris, Corolla and Auris for many years. This is a sequential manual transmission system, with a conventional diaphragm clutch. It comes in both...

...Peugeot 207: Knocking noise from steering mechanism when parking Question: A customer of ours with a 2007 Peugeot 207 is complaining of a knocking noise from the steering mechanism when manoeuvring or parking. We have heard the knocking noise and believe it may be coming from the power st...

...Issue date: 12th April 2019PAD1835 - Correct Shim Fitment - Ford FiestaInner PadsPlease note the pips on the inner pads Please note that the shim kit makes the inner pad directional and must therefore be fitted so that the disc rotates into the cutaway of the rubber shim.Outer Pads Step 1...

...The recommended intervals for changing brake fl uid vary tremendously depending on the manufacturer. This can be as often as every two years to actually never!For example, Chevrolet calls for a brake fl uid change on most models every 45,000 miles, while Honda states to do it every three y...

...Advanced Insulation Testing - 2007 Volvo XC70 2.4 D5 This Volvo was delivered as a non-start to the workshop, a code scan was performed that revealed multiple short circuits on various components. The first in the list was fuel pressure sensor short to positive. The loom at the connec...

...BMW 325Ci - Knocking Front Suspension It was not too surprising to find that the offside front lower ball joint on this 2001 BMW 325i had excessive wear. The knocking noise it was making as it drove along the road was enough to indicate attention was needed. The lower arm has two ball j...

  • img
  • Type

    Technical Bulletin

  • Current Measurement Tools and Process - Frank Massey
  • Mar 19

  • Autoinform (109) Contact
  • PDF

...Current measurement tools and process My experiences with current measurement goes all the way back to the dark days of off-car ECU testing, initially relying on load simulation with the ATP network 500 terminal. It became painfully obvious that load simulation could not fully, and accura...



1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 ...[Next 10 of 303 pages] ...