menu

Search 4,470 docs, articles & videos from the world’s leading Automotive part manufacturers

  

162 results found for febi

...39304 Water pump failure causing overheated engines A recent febi ProTip described the overheating problems that can indicate a broken water pump impeller. The problem can be seen on various Citroen, DS, Fiat, Ford, Jaguar, Lancia, Land Rover, Mitsubishi, Opel, Peugeot and Toyota...

...to fit: Nissan Almera, Almera Tino, Expert, Micra, Note, Primera, Sunny, Wingroad 1.0, 1.2, 1.4, 1.5, 1.6, 1.8 Petrol engines Problem Incorrect camshaft and crankshaft synchronization, giving symptoms of poor acceleration and erratic engine rpm. The engine control unit may also...

...Chevrolet and Opel/Vauxhall models with LDC, LDD, LWD, A12XEL, A12XER, B12XEL, Z12XEP, A14XEL, A14XER, B14XEJ, B14XEL, B14XER, Z14XEP engines Thermostat causing cooling system problems in Chevrolet and Opel/Vauxhall models Cooling system problems caused by a faulty thermostat was t...

...Antifreeze facts and basics Most driver’s understanding of the function of coolant is limited to expecting the coolant to not freeze in the winter or overheat in summer. That’s it. febi explains what the real requirements are. In truth, the requirements on coolant for stateof-...

...Fuel Filter Fitting febi 170357 To Fit: Various Citroën, Fiat, Ford, Jaguar, Lancia, Land Rover, Mitsubishi, Peugeot models Engine: 2.2 Diesel Fuel Filter Fitting he fuel filter replacement is a regular service item for Various Citroën, Fiat, Ford, Jaguar, Lancia, Land Rover, Mi...

...In 1.4 TDI 3-cylinder engines by VW, the balancer shaft and the oil pump are mounted on the ladder-type frame and are driven by a chain from the crankshaft. The components of the balancer shaft drive are susceptible to wear due to high loads and exceeding the oil change intervals. In the w...

...Want to test the chain drive of Mercedes-Benz models with M271 engine (EVO)? No problem!febi bilstein has the solution!The measuring chain tensioner has a graduated scale from 55 to 85. If all chain drive components, e.g. chain tensioner, chain, guide rails and sprockets, are in perfect co...

...Chain Tensioner PROBLEM:Rattling noises may occur in the area of the chain drive under certain operating conditions even though the chain tensioner and timing chain have been properly refitted. CAUSE:The manufacturer has modified the design of the chain tensioner. The version of the ch...

...Rear axle bush for wheel bearing housing PROBLEM:Knocking or creaking noises can occur in the region of the rear axle when driving. CAUSE:Due to its design, the life of the rear axle bush is shortened by poor road and weather conditions. The version originally fitted (Repl. no. 201 352...

...New design of the mounting bush for rear axle beams!febi bilstein has two versions of the mounting bush for rear axle beams in its range:• Hydraulic bush with metal case (febi no. 19928) with 69 mm outside diameter • Plastic rubber mount with plastic outer case (febi no. 31547) with 72...



1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 ...[Next 10 of 17 pages] ...
footerlogo
popup