menu

Search 4,558 docs, articles & videos from the world’s leading Automotive part manufacturers

  

180 results for "Ac not cold"

...to be replAc ed. The problem only affects vehicles built in April/May 1995 (control unit nos.: date of manufAc ture 564 and 565, the number is on the top of the control unit). Bulletin...

...enault EspAc e (JE) Temporary failure of the air conditioning / heating fan If in the case of the above-mentioned vehicles with the fabrication numbers listed below the air conditioning/heating fan should fail temporarily, a faulty cable connection on the relay carrier could be the cause...

...humidity. Ac cording to physical laws, this process is normal, and, from a technical point of view, harmless, as the reflector is protected against the influences of fogging. When the bulb is switched on, the air inside the lamp warms up. Thanks to the combination rear lamp ventilation, the...

...efore replAc ing the heating radiat or. To replAc e the heat exchanger, proceed as follows with the engine cold: • Depressurize the coolant circuit by opening the cap. • Unscrew the coolant expansi on tank. In the case of right-hand drive (RHD) vehicles remove the battery. • Use cla...

...efore replAc ing the control unit, however, the power supply to the condenser fan should be checked by using a circuit diagram. Bulletin...

...an be replAc ed by a more powerful 30 A fuse. In this case no changes are necessary to the wiring harness. Note: From March 2003 a modified wiring harness with a more powerful fuse has been used by the manufAc turer. Bulletin...

...of the brAc ket for the air conditioning compressor. Th is faulty alignment is the result of the tolerances of t he fastening holes in the brAc ket and compressor, which in turns leads to the drive belt not running straight. For the problem to be eliminated, the brAc ket has to be re-aligned...

...auge approAc hes the red range although the engine temperature is not too high, one possible cause could be the engine temperature sensor. The reason for this is the extreme sensitivity of this sensor. This leads to the temperature gauge indicating a value that is too high, although the...

...ot be replAc ed as an individual part. In this case the complete recovery bottle has to be replAc ed....

...UnsatisfAc tory temperature regulation through dirty sensors The interior temperature sensor is fixed in the air-stream of a miniature fan (mostly in the control unit). It sends the temperature of the interior air as a resistance value to the ECU (the measurement helps for comparison pu...



...[Previous 10 pages] ... 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18
footerlogo
popup