menu

Search 4,469 docs, articles & videos from the world’s leading Automotive part manufacturers

  

17 results for "Charging circuit test"

...sts Many Charging and starting system faults can be solved with the basic potential difference testing under operating loads. Any circuit should have little or no volt drop from end to end while under load. These include Charging power and ground circuits. Increased voltage drop levels se...

...sts Many Charging and starting system faults can be solved with the basic potential difference testing under operating loads. Any circuit should have little or no volt drop from end to end while under load. These include Charging power and ground circuits. Increased voltage drop levels se...

  • img
  • Type

    Tech Tip

  • Battery care, maintenance & diagnosis
  • Sep 19

  • Autoinform (109) Contact
  • PDF

...Improved Charging and cycle times • Additional internal plate components • Leak resistant to 55 deg. AGM performance improvements include: • 4x extended cycle times • Sealed plates at 1bar preventing loss of active material • Very low internal resistance • High energy...

  • img
  • Type

    Technical Bulletin

  • Current Measurement Tools and Process - Frank Massey
  • Mar 19

  • Autoinform (109) Contact
  • PDF

...or by disCharging a capacitor. The onset of complex control motors in vehicle systems demands a more responsive means of switching whilst, reducing where possible the current through the PCM. This method is referred to as pulse width modulation (PWM). By pulsing a circuit, the duty cycle...

...not over-Charging the technician thought. The technician who was very experienced in diagnostics, contacted me for advice on how to approach this issue, as they had not seen it before. As the vehicle was fitted with Stop Start and a battery monitoring module, we decided to scan all syst...

...lights, Charging , running the air conditioning). Moreover, in some instances the engine may need to be used to operate auxiliary units, such as loading cranes or in pump operation, without the vehicle driving a single kilometre. Fig. Oil consumption and oil loss | 5 Introduction...

...rting and Charging circuits. Connect a BNC cable from Channel A on the PicoScope to the positive battery terminal, and a ground point on the vehicle. Then connect a 2000 A current clamp to Channel B and position it around the starter motor feed cable. Follow the setup wizard in our Pi...

...ve to the Charging system. The charge rate is now in effect being controlled by the vehicle. This can be through ECU, engine control module, powertrain control module, etc. With the task of testing the Charging circuit becoming more difficult, the easy option is to simply replace the al...

...money by Charging for your skilled diagnostic time, and changing fewer parts....

  • img
  • Type

    Tech Tip

  • Time to inject some sense
  • Apr 15

  • Autoinform (109) Contact
  • PDF

...or by disCharging a capacitor, thus, increasing both current and rise time. In the case of ground switched injectors, it may be seeded by a small current, preparing it for the much larger opening current event. Piezo injectors, of course, follow a totally different discipline. They do how...



1 | 2