...axle(e.g. BMW ). This information are needed for the speed indication, cruise control and torque convert er slip control. Function The Vehicle speed sensor records a changing magnetic field produced by a rotating multipole disc. The magnetic field open and close a reed contac...
...BMW E 36, 38, 39 / M52 9/95 up to 8/96 Engine doesn't start During cranking the fuel pump and the ignition are inoperative. When starting the engine, the battery voltage drops heavily during cranking (up to 4 volt), and can cause the control unit to reset. If this reset occurs, before...
...BMW E 34 / E36 with engine M 40 / M43 Engine dies after starting, fault code 41 stored in the control unit If there are complaints about this vehicle concerning the fact that the engine dies after starting and that fault code 41 (air flow meter) is stored in the control unit, a possible...
...BMW 7 Series (E38), 5 Series (E39) with engines M51, M52, M60, M62 Buzzing noise from the engine compartment, battery discharged If there are complaints about the above-mentioned faults, the cause could be a faulty relay. The "sticking" relay of the ABS recirculating pump allows the pu...
...BMW E38 model year: 09/1998 – 10/1999 E39 model year: 10/1998 – 10/1999 Xenon light not working With these vehicles it can occur that one or both xenon headlamps cannot be switched on although the light switch is in the “dipped beam” position and the ignition has been switche...
...BMW 5 Series (E39) and 7 Series (E38) with M51, M52, M60, M62 engines ABS return pump runs permanently If there are complaints about the above-mentioned fault, a “sticking” ABS motor-type relay could be the cause. The motor-type relay causes permanent triggering of the ABS return...
...BMW E36 Automatic stability control (ASC) warning light comes on If there are complaints about the above-mentioned fault, this could be caused by several factors: - The front throttle valve is jammed - The cable pull from the setting motor to the throttle valve is set badly - Faulty...
...BMW, all models with M52 engine Hard starting with the engine warm If there are complaints about the above-mentioned fault, the camshaft sensors could be responsible. The customer could also complain about a lack of power when starting from rest. In addition, the fault codes 18 (exhau...
...BMW 5-series (E39) All models before 1 Nov. 2002 Insufficient power If this fault is complained about, then the cause may be defective ignition coils. Various error codes are stored and the engine control lamp lights. Backfiring may also be complained about. In that case, the ignition...
...ERBURG No.BMW , Fiat; Opel; Volvo Air mass sensor 7.22701.04/.05.0/.08.0 … .11.0; 7.22684.07.0 … .11.0Potential complaints:• Loss of power• Black smoke• Jerking• Limp home function• Fault lamp comes on• Fault code P0100 The right of changes and deviating pictures is re...