menu

Search 4,579 docs, articles & videos from the world’s leading Automotive part manufacturers

  

35 results found for REPXPERT

...46 December 2024/January 2025 AUTOBIZ On initial diagnosis, the “bite point” of the clutch seemed high, but also on starting and stopping the engine a rattle was evident from the bell housing area, indicating possible wear to the dual mass flywheel (DMF). A short road test c...

...10 September 2024 AUTOBIZ T he first step is organizing the correct parts. The following information will help the parts supplier identify the correct parts:• Is the vehicle front or rear wheel drive• Date of construction• Engine serial number This information is availab...

...This video shows how to change a timing belt with a partially dismantled accessory drive. All the key steps are shown and the special tools required are explained. The replacement interval of the timing belt is approx. 210000 km. An incorrect procedure or failure to follow the repair guide...

...Audi A4 Multitronic worn DMF replacement REPXPERT Alistair Mason is looking at something a bit different in this issue, an Audi A4 2.0 TDI that has covered just over 114,000 miles. The A4 is fitted with a CVT Multitronic gearbox. The customer has reported that they can hear a rattling n...

...LuK Clutch Academy Nissan Juke 1.5 dCi Workshop equipment used Vehicle lift ñ (two post is ideal) Engine support Transmission jack Clutch alignment tool Note ñ Prior to the repair, ensure you have the locking wheel bolt key if required. Gearbox removal With the vehicle plac...

...Potential tensioner setting problem Adjusting the timing belt tensioner on some Volkswagen and Audi 1.6/2.0 TDi EA288 engines, from 2012 on, requires a few particular steps that may not be obvious to a mechanic. If the tensioner is not set correctly, catastrophic engine failure may occu...

...Clutch damage due to incorrect greasing of the hub To ensure that the clutch functions properly after replacement, the contact point between the clutch disc hub and the toothing of the gearbox input shaft must be greased. Not just any lubricant should be used here, but a special high-pe...

...Ford DPS6 Dry double clutch replacement on the 6-speed gearbox DPS6, Ford The video shows the removal and installation of the dry double clutch on a Ford DPS6 6-speed transmission using Schaeffler special tools. You can see how an already used double clutch is pressed off the transmission...

...LuK Clutch Academy Civic 2.2 CTDi REPXPERT Alistair Mason, is replacing the clutch & dual mass flywheel (DMF) on a 2007 Honda Civic 2.2 CTDi that has covered just under 73,000 miles. The vehicle has been booked in to investigate a rattle/knock from the engine & also clutch judder when pu...

...The video shows the removal and installation of the dry double clutch on a C635 DDCT transmission using the Schaeffler special tools. You can see how the double clutch is removed from the transmission and installed. The replacement of the engagement and disengagement system is also shown....



1 | 2 | 3 | 4