menu

Search 4,469 docs, articles & videos from the world’s leading Automotive part manufacturers

  

27 results found for REPXPERT

...ABS failure codes due to damaged wheel bearings - What is a multipole encoder? After changing or repairing a wheel bearing, failure codes in the ABS system are not necessarily caused by the sensor itself. When installing wheel bearings with integrated ABS signal transmitters, the signal t...

...Explained: OAD / OAP and how to check an overrunning alternator pulley Today we show you the different variants (OAD, OAP) of the overrunning alternator pulley. How do Overrunning Alternator Pulley and Overrunning Alternator Decoupler differ in design and function? It also shows how to ch...

...Broken, defective V-belt tensioner on a 1.9 L TDI engine The video shows the cause of a broken tensioning element in the auxiliary drive. It discusses why a tensioning arm that was already renewed a few thousand kilometers ago can be broken again and what the actual problem is. The pre...

...Central Slave Cylinder Leaks or Cannot Be Bled - Defective due to Mounting Error? LuK 510007310 We regularly receive inquiries for defective central slave cylinders (part number 510007310) via the support hotline or the warranty department. All failures that occur at the first use of the...

...Central Slave Cylinder Leaks or Cannot Be Bled - Defective due to Mounting Error? LuK 510007310 Schaeffler REPXPERT We regularly receive inquiries for defective central slave cylinders (part number 510007310) via the support hotline or the warranty department. All failures that occur at...

...LuK Clutch Academy - Mini One (R52) REPXPERT Alistair Mason, is replacing the clutch assembly in a 2008 Mini One (R52), that has covered more than 72,000 miles. The customer had reported that the clutch was “slipping” under load, and a short road test confirmed the clutch was at the e...

...Workshop equipment needed: Gearbox removal Open the bonnet and, for safety reasons, disconnect the negative battery lead and then remove the gear linkage cables from the gearbox. To remove the front sub-frame, raise the vehicle lift to waist height, remove both front wheels, disconnect...



1 | 2 | 3
footerlogo
popup