menu

Search 4,469 docs, articles & videos from the world’s leading Automotive part manufacturers

  

27 results found for REPXPERT

...If the preload on the release bearing is too low, this will result in reduced comfort and damage to the clutch. This in turn results in whistling or chirping noises when the clutch is depressed, as well as damage to the release bearing and cup spring. Eventually, the clutch will fail. I...

...Repair a Wet Double Clutch - VAG DQ380/81, DQ500 Repair a Wet Double Clutch - DQ380/81, DQ500 (VW Group) with the LuK RepSet 2CT & Special Tools The video shows the removal and installation of a wet double clutch on a VW Group DQ380, DQ380, DQ500 transmission using Schaeffler's speci...

...LuK #LSC309 Slave Cylinder: No Bleeder Valve In the absence of a bleeder valve, Roger demonstrates a reverse bleed procedure. Reverse Bleeding...

...LuK Hydraulics: Reverse Bleeding A common culprit of a no-release condition is air trapped in the release system. Pre-bled systems may also contain small pockets of air that can cause headaches. Reverse-bleeding is a simple process that can remedy this problem. clutch slave cylinder &...

...Resetting the Dual Mass Flywheel tension ring |C635 DDCT Transmission|Alfa Romeo|Fiat|Jeep|Suzuki The video shows how to reset and lock the disengaged tension ring on an already used Dual Mass FlyWheel (DMF) using the Schaeffler Special Tool. This procedure must be carried out if the tr...

...Workshop equipment needed: Gearbox removal Open the bonnet and, for safety reasons, disconnect the negative battery lead and then remove the gear linkage cables from the gearbox. To remove the front sub-frame, raise the vehicle lift to waist height, remove both front wheels, disconnect...

...LuK Clutch Academy - Mini One (R52) REPXPERT Alistair Mason, is replacing the clutch assembly in a 2008 Mini One (R52), that has covered more than 72,000 miles. The customer had reported that the clutch was “slipping” under load, and a short road test confirmed the clutch was at the e...

...LuK Clutch Academy Juke 1.5 dCi REPXPERT Alistair Mason is replacing the clutch & dual mass flywheel (DMF) on a 2011 Nissan Juke 1.5 dCi, with a very heavy clutch pedal. After some initial diagnosis, gearbox removal was advised & authorization given. With a recommended repair time of 4...

...LuK Clutch Academy Civic 2.2 CTDi REPXPERT Alistair Mason, is replacing the clutch & dual mass flywheel (DMF) on a 2007 Honda Civic 2.2 CTDi that has covered just under 73,000 miles. The vehicle has been booked in to investigate a rattle/knock from the engine & also clutch judder when pu...

...Clutch Replacement Ford Focus 1.6 EcoBoost REPXPERT Alistair Mason is replacing the clutch and dual mass flywheel (DMF) in a 2012 Ford Focus 1.6 EcoBoost that has covered more than 86,000 miles. The customer reported that the vehicle was difficult to get into gear and the initial diagn...



1 | 2 | 3
footerlogo
popup