menu

Search 3,849 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3838 results

...Identification of Calipers LCA / RCA 155 & LCA / RCA 244Further information on this or any other issue can be obtained from the Apec Trade Helpline 01454 285054 Issue date23rd January 2014TechnicalBulletin.These Calipers are fitted on the rear of Nissan Primastar [2002-]Opel Vivaro [2001...

...Bulletin Disc Brake Minimum Thickness www.apecbraking.co.uk For the very latest information on Apec Braking components.Date: 17th August 2012For part numbers/make & models: DSKs Every Apec disc manufactured is produced in line with the original disc parameters. The Minimum Thickness of a...

...BulletinDiscs – how low should you go?www.apecbraking.co.uk For the very latest information on Apec Braking components.Date: 17th August 2012For part numbers/make & models: all DSKsIt's fairly obvious when brake pads become too worn and thin to be safe – but what about brake discs? T...

...BulletinFord Transit Rear Drums & Judder www.apecbraking.co.ukFor the very latest information on Apec Braking components.Date: 3rd March 2009For part numbers/make & models: all 5 and 6 stud applications We would like to bring to your notice the importance of fitting and securing Ford Tran...

...A number of Apec Brake Discs are handed to aid cooling as per the original equipment disc. Follow venting direction not drill hole pattern. Failure to follow this installation rule will lead to poor performance and possible brake judder. DSK2003 / 2004 DSK2308 / 2309 DSK2310 / 2311...

...Old worn out-parts causes: • Tension of springs significantly reduced. • The old parts break or are lost. Old worn out-parts increases the risk of: • Brake noise (the brake pads and clip rattle}. • Unequal and disproportionate wear on the brake pads and a risk of damaging t...

...Bulletin How to Cure Brake Judder www.apecbraking.co.uk For the very latest information on Apec Braking components.Date: 12th October 2010For part numbers/make & models: all DSKsA bad case of the shakes Judder is one the most annoying faults that can occur with braking systems, and if...

...Issue date25th June 2014TechnicalBulletin.When replacing shoes for the EPB on Landrover Discovery it is essential that the correct procedure is followed to ensure correct actuation. Failure to do this could result in premature lockup and expensive component failure. Bedding in of the shoes...

...Issue dateFebruary 2015TechnicalBulletin.The Electronic Parking Brake Module, also known as the EPB actuator, is fitted to the Range Rover Sport from 2005 onwards and the Land Rover Discovery 3 & 4. Whilst generally reliable we wish to draw your attention to the following installation proc...

...Land Rover Freelander pad fitting instructionswww.apecbraking.co.uk For the very latest information on Apec Braking components.Date: 21st September 2009For part numbers/make & models: PAD 1208PAD 1208 - Land Rover Freelander - All derivatives from VIN 1A 576764Fitment of replacement brake...



1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 ...[Next 10 of 384 pages] ...