menu

Search 4,470 docs, articles & videos from the world’s leading Automotive part manufacturers

  

35 results for "BMW engine fault code"

...BMW E 36, 38, 39 / M52 9/95 up to 8/96 Engine doesn't start During cranking the fuel pump and the ignition are inoperative. When starting the engine, the battery voltage drops heavily during cranking (up to 4 volt), and can cause the control unit to reset. If this reset occurs, before...

...BMW E36 Automatic stability control (ASC) warning light comes on If there are complaints about the above-mentioned fault, this could be caused by several factors: - The front throttle valve is jammed - The cable pull from the setting motor to the throttle valve is set badly - Faulty...

...BMW E 34 / E36 with engine M 40 / M43 Engine dies after starting, fault code 41 stored in the control unit If there are complaints about this vehicle concerning the fact that the engine dies after starting and that fault code 41 (air flow meter) is stored in the control unit, a possible...

...To fit: BMW X3 (E83), X5 (E53, E70), X6 (E71, E72)Problem A clicking noise can be heard from underneath the vehicle - around the area of the transfer case - when switching the ignition on or off.The engine is jerky in operation when accelerating in lower gears.The ABS, 4x4 and brake syst...

...BMW 5-series (E39) All models before 1 Nov. 2002 Insufficient power If this fault is complained about, then the cause may be defective ignition coils. Various error codes are stored and the engine control lamp lights. Backfiring may also be complained about. In that case, the ignition...

...BMW 5 Series (E39), 7-series (E38) Model years 09.1998 to 09.2000 All models with Bosch ASC 5.7 or DSC 5.7 and Servotronic Failure of power steering If the customer complains about the above problem, this could be caused by the controller for the ABS/anti- skid system (ASC) and the...

...BMW 5 Series (E39) and 7 Series (E38) with M51, M52, M60, M62 engines ABS return pump runs permanently If there are complaints about the above-mentioned fault, a “sticking” ABS motor-type relay could be the cause. The motor-type relay causes permanent triggering of the ABS return...

...This BMW came to the workshop with a rather unusual emissions failure. It had failed the NCT test on  emissions test, with a very high level on the Lambda reading. The first step taken was to scan the engine management system for fault codes, but no codes were stored. The data fo...

...2008-On BMW 3.0 Petrol E90/92/93 Series 335i N54830A/B A known fault exists which is caused due to the power steering pump pulley or auxiliary belt coming into contact with the sub-frame when driving over speed humps. This contact between the components can cause the auxiliary drive be...

...Helpline BMW 218 with engine noise and poor engine performance The subject car was a BMW 218 with engine code B38B15A. On initial scan of the BMW , a fault code 130308 (Exhaust Cam position not reached) was present. This code was indicating a valve timing position error, and the engine wa...



1 | 2 | 3 | 4
footerlogo
popup