menu

Search 4,560 docs, articles & videos from the world’s leading Automotive part manufacturers

  

187 results for "Ac not cold"

...humidity. Ac cording to physical laws, this process is normal, and, from a technical point of view, harmless, as the reflector is protected against the influences of fogging. When the bulb is switched on, the air inside the lamp warms up. Thanks to the combination rear lamp ventilation, the...

...pecific plAc es to avoid contAc t with the brake disc and the brake system. The contents of these cleaning agents can lead to damage to the brake system, impaired braking and permanently decreased comfort. Recommendation Apply these products with care, because less is more in this...

...f V ReplAc ing the light source If the light source has to be replAc ed with the above-mentioned vehicle, particular attention must be paid to a special feature. If a defective bulb is established during the light function check, the ignition should be switched off before replAc ement tak...

...of the brAc ket for the air conditioning compressor. Th is faulty alignment is the result of the tolerances of t he fastening holes in the brAc ket and compressor, which in turns leads to the drive belt not running straight. For the problem to be eliminated, the brAc ket has to be re-aligned...

...d and replAc ed if necessary. The vehicle manufAc turer recommends the spark plug type: - Spark plug type: FGR 8 KQE0 - Tightening torque 25 Nm - Electrode gap 1.35 mm A frequent cause of failure is short-range operation or frequent cold starts. Fault patterns and possible causes (tighten...

...an be replAc ed by a more powerful 30 A fuse. In this case no changes are necessary to the wiring harness. Note: From March 2003 a modified wiring harness with a more powerful fuse has been used by the manufAc turer. Bulletin...

...st be replAc ed. The sensor can be ordered wholesale using HELLA part number 6PU 009 1 46-631 (see Fig.)....

...to be replAc ed. The problem only affects vehicles built in April/May 1995 (control unit nos.: date of manufAc ture 564 and 565, the number is on the top of the control unit). Bulletin...

...ot be replAc ed as an individual part. In this case the complete recovery bottle has to be replAc ed....

...auge approAc hes the red range although the engine temperature is not too high, one possible cause could be the engine temperature sensor. The reason for this is the extreme sensitivity of this sensor. This leads to the temperature gauge indicating a value that is too high, although the...



4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 ...[Next 10 of 19 pages] ...
footerlogo
popup