menu

Search 4,652 docs, articles & videos from the world’s leading Automotive part manufacturers

  

180 results for "Ac not cold"

...e and replAc ement of the turbocharger with an OE part, the vehicle was returned to the customer working as expected. Within a few hours, the customer was bAc k in the workshop with the same symptoms. A deeper look into the scan data revealed rather higher than normal oil pressure. From col...

...time to reAc h its normal operating temperature, or may not reAc h it at all. When fluctuations in the coolant temperature occur in vehicles with a direct-shift transmission, a defective transmission oil thermostat may be the cause.Such temperature fluctuations frequently occur in overrun mo...

...resistor pAc k. On a large proportion of failed heater blowers I see, the heater resistor is the cause of the failure. Even when the blower does not operate on full speed, the resistor should not be ruled out. It is always worth checking the resistor. It was the motor itself that had faile...

...s one was Ac tually in the bulb holder itself. Water had entered the lamp and had severely corroded the bulb holder. The bulbs had rusted into plAc e, and the possibility of removing the bulbs and restoring the bulb holder to service was minimal. The best option was to find another bulb ho...

...s one was Ac tually in the bulb holder itself. Water had entered the lamp and had severely corroded the bulb holder. The bulbs had rusted into plAc e, and the possibility of removing the bulbs and restoring the bulb holder to service was minimal. The best option was to find another bulb hol...

...y used to Ac hieve the stricter limit values of Euro 6/Tier 2. EGR allows exhaust gas to be mixed in with intake air at varying amounts, as required. This means that less oxygen reAc hes the cylinder overall, leading to lower combustion temperatures. As a result, the amount of nitrogen ox...

...ll as the Ac tual physical checks, of the vehicle? Do you check vehicle scan tool data? Things that we often see are glow plug faults, and fuel additive levels getting low, often without any complaint from the customer. When glow plugs crop up during our inspection, we generally carry ou...

  • img
  • Type

    Technical Bulletin

  • Mazda Ignition Coil Problem

  • Nov 23

  • Blue Print (214) Contact
  • PDF

...nclude a lAc k of engine power and an inconsistent idle, combined with the engine malfunction indicator lamp being illuminated on the instrument cluster. Engine Control Unit (ECU) diagnostics will reveal the following possible fault codes: P0300 - Misfire Detected. P0301 - Misfire Detecte...

...dosage exAc tly right. If too much contrast agent is used, it can clog the valves in the compressor or the solenoid valves of the air conditioning service unit, among other things. It can only be used as a preventive measure: Only leaktight air conditioning systems may be filled with...

...Easily Ac cessed on this engine, I removed the connecting feed wire to the glow plugs and used the ammeter to check the resistance of eAc h plug. Three out of the four did not pass the test, and as these are more old school glow plugs, not the more expensive type often used now, I decided...



1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 ...[Next 10 of 18 pages] ...
footerlogo
popup