menu

Search 4,469 docs, articles & videos from the world’s leading Automotive part manufacturers

  

3196 PDF Files Listed

...Installation tip for tensioning pulley CT1114K1 and CT1115K1 for various Fiat, Ford, Lancia, Alfa 1.1-1.4 engines Problem: During installation, the spring is seen to be detached from the pulley, which means that it is no longer possible to set the tension. Cause: Inexpert handling...

...© MS Motor Service International GmbH –1108 ENwww.ms-motor-service.comMS Motor Service International GmbH · 74196 Neuenstadt · GermanyKolbenschmidt Pierburg grou PS E R V I C EIN f o r Ma t Io NSI 0097fuel tank electric fuel pump fuel filter (fine filter)electric fuel pump, type E1Fsi...

  • img

  • Tech Tip

  • LuK Clutch Academy Ford Focus 1.8 TDCi

  • Oct 17

  • LuK (131) Contact
  • PDF

...LuK Clutch Academy - Ford Focus 1.8 TDCi The Ford Focus is a popular car, so clutch replacement is a frequent undertaking. To ensure a quality repair inside the scheduled time of four and three-quarter hours, requires strict adherence to the correct procedure. Scheaffler's Malcolm Short...

...Continental Contitech Technical info 71 ContiTech Antriebssysteme GmbH Techn. Hotline +49 (0)511 938 -5178 www.continental-engineparts.com Philipsbornstraße 1, D-30165 Hannover E-Mail: aam@continental.com The content of this publication is non-binding and is...

  • img

  • Component Description

  • Water pump failure causing overheating

  • Oct 22

  • Blue Print (201) Contact
  • PDF

...Blue Print ADC49169 To fit: various Citroen, DS, Fiat, Ford, Jaguar, Lancia, Land Rover, Mitsubishi, Opel, Peugeot, Toyota and Vauxhall models Water pump with gasket Water pump failure causing overheating Problem The engine coolant temperature and engine management warning lamps...

  • img

  • Tech Tip

  • Nissan Navara, Jim Investigates

  • Feb 12

  • Blue Print (201) Contact
  • PDF

...Jim Investigates... Nissan Navara Remaining Neutral Whilst at a recent garage visit, we met a technician who had a peculiar problem with a 2003 Nissan Navara 2.5TD. He’d spent many hours trying to figure out why it kept losing power, yet there was no fault stored in the ECU and no en...

...Audi A2 1.4 TDI Replacing the light source As the instructions for this vehicle are the same for both sides, they are stated here for one side only. First, switch the ignition off. In order to gain access to the engine bay, the bonnet must be removed. Proceed as follows: - Unlock the...

...Ford Mondeo III built from 11.2000-09.2001 1.8l / 2.0l Duratec HE engine Vehicle is difficult to start when it has been parked for a long or short period. If the vehicle is difficult to st art after being parked for a long or short period and idles badly after starting, one possibl...

...Audi A3, A4, A6, A8 Airbag light comes on If there are complaints about the above-mentioned fault, a faulty plug connection between the interior wiring harness and the airbag module could be the cause. In this case, replace the plug by using crimp connectors with flux. Carry out t...

...Opel Astra-F/G, Vectra B, Calibra, Omega B with engine: C18XE, C18XEL, X20XEV Engine warning light comes on and fault code P0340 is stored in the control unit. If there are complaints with these vehicles that the engine warning light comes on and the fault code P0340 (camshaft position...



...[Previous 10 pages] ... 23 | 24 | 25 | 26 | 27 | 28 | 29 | 30 | 31 | 32...[Next 10 of 320 pages] ...
footerlogo
popup