136 results found for Blue Print

• 
• Type

  Installation Instructions

• Mazda 6, 323, 626, Premacy Rear Brake Caliper Fitment Guide

• Nov 01

• Blue Print (204) Contact
• 

...Blue Print brake calipers are supplied pre-set to fit with new brake pads and discs without adjustment. If disc or pad wear has taken place (or the piston is retracted during fitment), MANUALLY ADJUST THE PISTON TO WITHIN 1MM OF THE PADS. If the piston is forced to adjust further than 1mm...

• 
• Type

  Part Info Sheet

• Mitsubishi Pajero Starter Motor Power Ratings

• Mar 04

• Blue Print (204) Contact
• 

...Mitsubishi Pajero Starter Motor options ADC41215 and ADC41217  Blue Print currently catalogue a choice of two starter motors on some of the Mitsubishi Pajero (grey import)  applications. They are listed as 2.0kW or 2.2kW power ratings. It is imperative that the correct part is id...

• 
• Type

  Technical Bulletin

• Opel 1.5DT, 1.7DT (Isuzu Engine) Alternator Replacement

• Nov 01

• Blue Print (204) Contact
• 

...ADZ91107 and ADZ91113 Alternators We are aware of common vehicle faults associated with the charging system on Vauxhall Opel applications using the Isuzu 1.5 and 1.7 diesel engines. The aim of this bulletin is to allow the correct diagnosis prior to replacing the alternator, and to assist...

• 
• Type

  Part Info Sheet

• Isuzu Trooper Rear Caliper Instilation Guide

• May 04

• Blue Print (204) Contact
• 

...Isuzu Trooper Rear Caliper Application ADZ94507R and ADZ94508R ( UBS52 and UBS55 models )  Rear Caliper Slider Length Option Some of the ADZ94507R and ADZ94508R Trooper applications will have either a 55mm or 74mm slider tube fitted in the original caliper (see diagrams below). From Apri...

• 
• Type

  Installation Instructions

• Toyota Carina E and Avensis Water Pump Replacement

• Jul 02

• Blue Print (204) Contact
• 

...Toyota Carina E and Avensis Water Pumps ADT39145 (Aisin) & ADT39177 (SEM) - 7AFE 1.8 engine ADT39143 (Aisin) & ADT39159 (SEM) - 4AFE 1.6 engine Blue Print catalogue a choice of water pump after specific manufacturing dates on the Carina E (AT190 & AT191) and the Avensis (AT221) models...

• 
• Type

  Technical Bulletin

• Mitsubishi Clutch Replacment - Mainshaft Flywheel (Spigot) Bearing Failure

• May 06

• Blue Print (204) Contact
• 

...We have encountered several cases of flywheel (spigot) bearing failure on some Mitsubishi models. The flywheel should be carefully checked or replaced when installing a new clutch assembly. The following points should be noted during routine clutch replacements: A seized flywheel bearing m...

• 
• Type

  Technical Bulletin

• Hyundai Lantra 1.6, 1.8 KF Model Timing Belt Replacment

• Jul 02

• Blue Print (204) Contact
• 

...Hyundai Lantra 1.6/1.8 KF Models Only (With G4CR or G4*N DOHC engines) Caution when fitting ADC47514 Timing Belt We have experienced several claims for ‘timing belt failure’ on the above model. Thorough investigation has identified the cause as insufficient timing belt operat...

• 
• Type

  Technical Bulletin

• Nissan Micra K10 Clutch Kit Replacement

• Jul 02

• Blue Print (204) Contact
• 

...Nissan Micra K10 Series Clutch We have found that the Nissan Micra suffers from common problems causing premature clutch failure. Awareness of these problems prior to fitment will allow the correct preventative action to be taken. Symptoms: Jerky/stiff pedal operation Clutch drag (poor ge...

• 
• Type

  Installation Instructions

• Nissan Micra K10 Alternator Replacement

• May 04

• Blue Print (204) Contact
• 

...Nissan Micra Alternator ADN11105 / ADN11110 / ADN11112 / ADN11113 We have experienced several instances where the above alternators have been fitted to a Nissan Micra and have appeared not to be charging the battery. Our investigations have shown that, in most cases, the problem is due to...

• 
• Type

  Installation Instructions

• Toyota Supra 3.0i Head Gasket Replacement

• Jul 02

• Blue Print (204) Contact
• 

...INF040 Toyota Supra 3.0i Head Gasket Replacement We have encountered several instances of head gasket failure on the Toyota Supra 3.0 turbo and non turbo models resulting from engine overheating. It is our understanding that, if the engine is allowed to overheat, cylinder head distortion...