menu

Search 4,558 docs, articles & videos from the world’s leading Automotive part manufacturers

  

134 results found for MAHLE

...Technical MessengerWorkshop InformationIssue no. 08/2016: Shaft separation in alternatorswww.mahle-aftermarket.comFigure 1: Separated threadFigure 2: Impact drivers are only used to loosen the pulley, NEVER to tighten it!Figure 3: Always use a hold-down tool and torque spanner to tighten t...

...www.mahle-aftermarket.comThermosTa T fiTTing 1. removal 2. Tes Ting 3. fiTTing ✔ Caution: working on cooling systems can cause burns. ✔ Never open a cooling circuit unless it is cold and depressurised. ✔ Drain the coolant and dispose of it in accordance with regulations. ✔ Che...

...Technical MessengerWorkshop InformationIssue no. 7/2016: Foreign object damage in the turbocharger www.mahle-aftermarket.comFigure 1Figure 2 Abbildung 2: Handelsübliches Vakuum-Entlüftungs-Gerät. IMPORTANT! It is crucial that the loose impeller nut be found and removed. The entire in...

...www.mahle-aftermarket.comVALVE FITTING1. REMOVAL2. TESTING3. FITTING✔ Remove the cylinder head as per manufacturer specifications. ✔ Mark all parts and note the installation direction. ✔ Do not place the removed cylinder head on its end face as this could damage the valve. ✔...

...Technical Messenger Issue no. 06/2016: Workshop InformationIssue no. 06/2016: Thermal problems after a thermostat change: air in the cooling circuit www.mahle-aftermarket.comFigure 3: A vacuum is created in the system by means of the Venturi effect.Figure 1: When the cooling circuit is...

...Technical Messenger Issue no. 05/2016: Workshop InformationBlue smoke coming from the exhaust and oil leaking on the exhaust side of the turbocharger just a few kilo- metres after the turbocharger has been replaced are often misdiagnosed initially—but the new turbocharger is not to...

...DdL77orNon-mag -netic stem and headMagnetic stem and headDdL7Magnetic stemNon-mag-netic headDdLSodium, lique\fes at 9 7. 5 ° CMono-metallic valveBi-metallic valveSodium-filled hollow valveTypes and technical termsMono-metallic valvesare produced efficiently in a hot-extrusion process or...

...IMahle Technical bulletin 4/2016 Issue no. 04/2016: Leaky oil filters: oil pressure regulating valve clogged www.mahle-aftermarket.com, page 1In vehicles with spin-on (OC) oil filters, leakage from the filter or oil loss from the filter's screw-on flange may occur due to a clogged contro...

...Decline in turbocharger performance—diesel particulate filter loading limit reached Mahle Technical Messenger 3 for 2016 Issue no. 03/2016: Decline in turbocharger performance—diesel particulate filter loading limit reachedwww.mahle-aftermarket.com, page 1If performance issues con...

...Issue no. 02/2016: Comparison of MAHLE oil filter inserts OX 404 and OX 813/1 www.mahle-aftermarket.com, page 1The oil filter inserts OX 404 and OX 813/1 have a closure plug on the front end, usually called pin at MAHLE. When the insert is removed, this pin reveals a return bore in the fi...



...[Previous 10 pages] ... 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14