menu

Search 4,364 docs, articles & videos from the world’s leading Automotive part manufacturers

  

22 results found for REPXPERT

...Workshop equipment needed: Gearbox removal Open the bonnet and, for safety reasons, disconnect the negative battery lead and then remove the gear linkage cables from the gearbox. To remove the front sub-frame, raise the vehicle lift to waist height, remove both front wheels, disconnect...

...LuK Clutch Academy - Mini One (R52) REPXPERT Alistair Mason, is replacing the clutch assembly in a 2008 Mini One (R52), that has covered more than 72,000 miles. The customer had reported that the clutch was “slipping” under load, and a short road test confirmed the clutch was at the e...

...36 February 2023 AUTOBIZ See this and 1,000s more Tech Tips on TechTips.ie36 February 2023 AUTOBIZA CSC is, essentially, four clutch components in one: a slave cylinder, pivot/actuation lever, release bearing and guide tube – all in a compact, lightweight unit that...

...LuK Clutch Academy 2014 Hyundai i30 REPXPERT Alistair Mason is investigating a clutch fault on a 2014 Hyundai i30, which has covered more than 162,000 miles. The customer had reported that it was difficult to get the vehicle into gear. With full workshop instructions available on Schaeffl...

...Clutch Replacement Audi A1 1.6TDi REPXPERT Alistair Mason is investigating a clutch fault on a 2013 Audi A1 1.6 TDI that has covered more than 45,000 miles. The car was booked in to investigate clutch slip and a short test drive confirmed the problem, so the customer was advised clutch...

...Clutch Replacement Ford Focus 1.6 EcoBoost REPXPERT Alistair Mason is replacing the clutch and dual mass flywheel (DMF) in a 2012 Ford Focus 1.6 EcoBoost that has covered more than 86,000 miles. The customer reported that the vehicle was difficult to get into gear and the initial diagn...

...LuK #LSC309 Slave Cylinder: No Bleeder Valve In the absence of a bleeder valve, Roger demonstrates a reverse bleed procedure. Reverse Bleeding...

...LuK Hydraulics: Reverse Bleeding A common culprit of a no-release condition is air trapped in the release system. Pre-bled systems may also contain small pockets of air that can cause headaches. Reverse-bleeding is a simple process that can remedy this problem. clutch slave cylinder &...

...44 November 2022 AUTOBIZLuk Clutch Academy2015 Kia Carens Alistair Mason, Schaeffl erGarageTech TipsREPXPERT Alistair Mason is replacing the clutch & dual mass flywheel in \ a 2015 Kia Carens, fitted with a 1.7 CRDi engine that has covered more than 112,000 miles. Kia launched...

...Control arm, stabilizer and air suspension on the rear axle - S211 Mercedes Benz E-Class The time has come, once again the experts from Schaeffler and Bilstein meet to share workshop-relevant information. This time in the form of a joint video. As experts in suspension parts (Schaeffler)...



1 | 2 | 3
footerlogo
popup