3838 results

• 
• Type

  Technical Bulletin

• Alternator failure due to oil ingress

• Jun 17

• MAHLE (139)
• 

...Technical MessengerWorkshop InformationIssue No. 06/2017: Alternator failure due to oil ingresswww.mahle-aftermarket.comFigure 1: Oil residue in the alternatorFigure 2: Heavy wear on the slip rings (left) and carbon brushes (right) Figure 3: Depending on the installation position, it is i...

• 
• Type

  Technical Bulletin

• Alternator not charging

• Jul 18

• MAHLE (139)
• 

...Alternator not working Technical MessengerWorkshop InformationIssue no. 04/2018: Alternator not workingwww.mahle-aftermarket.comIMPORTANT: Always interrupt the electrical circuit (disconnect the battery earthing cable) before performing any work on the alternator. Labeling the connections...

• 
• Type

  Service Information

• Alternator OAP - Features and Benefits

• Jun 11

• Gates (127) Contact
• 

...Did you know that some solid alternator pulleys have been replaced by a patented pulley technology that is an important part of the drive system design? These new high tech alternator decoupler pulleys (ADP) allow the belt to power the alternator during acceleration and cruising speed, but...

• 
• Type

  Technical Bulletin

• Alternator Over-Charging Or Charging With Warning Light On

• Mar 16

• Autoelectro (21)
• 

...THIS BULLETIN ONLY APPLIES IF YOU HAVE THE FOLLOWING 3-PIN STRIP PLUG ON THE ALTERNATOR: A known fault exists which can result in a charging fault. This can be the alternator showing as overcharging and/or charging with the warning light on. This alternator is operated through a sma...

• 
• Type

  Technical Bulletin

• Alternator overrunning pulley problem on Mazda

• Jun 23

• Blue Print (201) Contact
• 

...Blue Print ProTip ADM561302 Alternator overrun pulley To fit: Mazda CX-30, CX-3, CX5 I & II, Mazda 2 III, Mazda 6 III & IV Engines: 1.5d, 1.8, 2.2d Problem The vehicle becomes difficult to start and displays signs of overheating, and/or there is a ‘squealing’ noise from th...

• 
• Type

  Technical Bulletin

• Alternator Pulley/Bearing Failure Caused by Water Contamination

• Jun 17

• Autoelectro (21)
• 

...Alternator pulley/bearing failure caused by water contamination on crankshaft pulley Ford Transit 2.2TDCi 2006-2012 Part Number affected: AEK2977 A known fault exists which can result in a charging fault and/or noise from the drive belt system. The fault occurs due to water and dirt...

• 
• Type

  Component Description

• Alternator pulley/bearing failure caused by water contamination on crankshaft pulley

• Nov 17

• Autoelectro (21)
• 

...This fault is found on Ford Transits with 2.2TDCi engines from 2006 to 2012 (Alternator Part No. AEK2977) A known fault exists which can result in a charging fault and/or noise from the drive belt system. The fault occurs due to water and dirt contaminating the crankshaft pulley and causin...

• 
• Type

  Service Information

• Alternator Shaft Separation

• Nov 16

• MAHLE (139)
• 

...Technical MessengerWorkshop InformationIssue no. 08/2016: Shaft separation in alternatorswww.mahle-aftermarket.comFigure 1: Separated threadFigure 2: Impact drivers are only used to loosen the pulley, NEVER to tighten it!Figure 3: Always use a hold-down tool and torque spanner to tighten t...

• 
• Type

  Technical Bulletin

• Alternator/Starter Failure Caused by Fuel and Water Ingress

• Sep 17

• Autoelectro (21)
• 

...Alternator/Starter Failure Caused by Fuel and Water Ingress The number of failures caused due to fluid contamination is rising. Many applications now have starter motors and alternators installed under or around some form of lubricant/fluid component or pipes. Fuel filters, power steering...

• 
• Type

  Technical Bulletin

• Alternators & Starters - Choosing the Right One

• Apr 16

• Autoelectro (21)
• 

...Vehicle platforms having overlaps on year of manufacturer are increasingly common. This leads to changes and variations of the models and choices of parts fitted to the vehicle. A common misconception is that ‘they look the same so it will be fine’, but this is not always the cas...