menu

Search 4,561 docs, articles & videos from the world’s leading Automotive part manufacturers

  

14 results for "sheared timing belt"

...sheering sheared teeth sheared belt sheered teeth sheered belt sheered timing belt Tooth shear occasionally occurs on certain engines with an oval crankshaft sprocket, often after work has been carried out on the high-pressure fuel pump. This might happen, for example, when replaci...

...th can be sheared off the timing belt during initial start-up after belt replacement, or after a short mileage after replacement. When this problem occurs on the following Euro 6 diesel engine Makes/Models: Opel 2.0; Citroen/ Peugeot 2.0/ 2.2 Blue HDi; Ford 2.0 TDCi / ECOnetic / ECOBlue; T...

...Teeth are sheared off the timing belt during the starting process or after a short mileage. CT1140K2 and CT1140WP2. Various diesel engines Euro 6: Opel 2.0; Citroen/ Peugeot 2.0/ 2.2 Blue HDi; Ford 2.0 TDCi / ECO netic / ECOBlue; Toyota 2.0 D4d Problem: Teeth are sheared off during th...

...have been sheared off the timing belt, the tensioner pulley arrester body is torn and the full load stop is incorporated (Fig. 1). Cause During the tensioning procedure, the hole in the tension indicator is brought into contact with the hole in the arrester body. As a result, the tension...

...have been sheared off the timing belt, the tensioner pulley arrester body is torn and the full load stop is incorporated. Cause: During the tensioning procedure, the hole in the tension indicator is brought into contact with the hole in the arrester body. As a result, the tension is se...

...have been sheared off the timing belt, the tensioner pulley arrester body is torn and the full load stop is incorporated. Cause: During the tensioning procedure, the hole in the tension indicator is brought into contact with the hole in the arrester body. As a result, the...

...e system sheared TEETH CAUSE: Fitting error: - Incorrect tension - Misalignment Change point exceeded WORN TOOTH FLANKS CAUSE: Fitting error: - Incorrect (excessive) tension - Misalignment Change point exceeded MARKED BELT BACK CAUSE: Fitting error: - Incorrect tension / al...

...e system sheared teeth – caused by incorrect tension and misalignment (fitting error), or the recommended change point has been exceeded Cracked back – caused by heat exposure and/or change point exceeded Side wear/polishing – caused by misalignment (fitting error) Worn teeth fla...

...n peg had sheared off and the pulley had spun on the camshaft. A new pulley was ordered and fitted, but the belt seemed too long. It is worth noting that the F9Q 1.9 engine has a few variations, and the Di and DCi have differing teeth counts on the timing pulleys. The correct pulley wa...

...e bolt is sheared offCAUSES• Inadequate tightening torque• Fatigue of the bolt caused by the up and down motion of the roller. Bolt subjected to shearNTN-SNR RECOMMENDATIONS• Tighten the bolt to the specified torque• Oil the smooth part (seat) of the retaining bolt. Note oil must...



1 | 2