menu

Search 4,470 docs, articles & videos from the world’s leading Automotive part manufacturers

  

38 results found for FAI

...faiauto.comHG2101 uses latest OE modification.Mitsubishi 4D56T 16V Engines Following OE modification, FAI now offers the latest design head gasket for Mitsubishi 4D56T 16V engines. The new design has a corrugated upper surface and smooth profile lower layer, completely matching OE. This g...

...LINK ROD TIGHTENING ADVICE FA I recommend that an airgun should not be used to tighten the nuts on a link rod. Using an airgun increases the risk of .........• Over - tightening• Snapped ball pin• Cross threading - shearing thread FA I recommend that only a suitable manual tool s...

...faiauto.comInstallation informationPTFE Oil SealsImportant :• Ensure contact surfaces are clean, dry and damage free.• Carefully push seal into position, without damaging the PTFE material.• When fitted, do not start engine for a minimum of 4 hours.Važno:• Postarajte se da je kont...

...faiauto.com Choosing the correct oil pump Hyundai/Kia/Mitsubishi 2.5 TD EnginesOP342OP271OP270 OP264Raised Bolt Fixing Machined Flat Fixing Raised Bolt Fixing Raised Bolt Fixing HYUNDAI - 2134042800Engines: 4D56T/4D56TD MITSUBISHI - MD181583Engines: 4D56T/4D56TDMITSUBISHI - MD364254Engin...

...faiauto.com Before fitting a replacement head gasket Head Surface Finish Ensure the cylinder head and engine block surfaces have been checked, ensuring level sealing surfaces.Maximum values: Roughness...

...faiauto.comEssential Fitting Information TCK4S/TCK4NGSThe original GM timing gears for this engine up to engine number 19DN0327 were made from sintered material and included a built in spacer/washer. Later engines used pressed steel gears which did not require the spacer/washer. GM have st...

...Certificate GB00454Technical Bulletin www.faiauto.com Tel: 08708 391802 Best Availability. Best Price.Best Quality. Best Service. LEAF8450The contents of this kit have been assembled as a â...

...Wheel end bearings SuspensionAxial rods Steering Rack Gaiter KitsStabilizer Link BarsRubber-to-Metal Track control arms General informationWheel end bearingsDrag Links and Centre ArmsTie rod ends V-Torque rodsBall jointRepair kitsTie rod assemblies Expert tipsSteeringWishboneLight Vehicle...

...faiauto.comFord 2.2 & 2.4 Duratorq Bolt Torque Settings CAUTION: Damper pulley retaining bolts MUST only be used 3 times Best Practice:After installation, stamp the damper pulley bolt head with a centre punch to indicate usage. The bolts should be tightened in 2 stages Stage 1: 30 Nm Stage...

...faiauto.comIdentifying the correct timing marksTCK7 Installation tipsEngine Codes: 1.6 HDi 16V (DV6) used by Citroen, Peugeot, Ford, Mazda & Volvo.Issue: Engines are fitted with one of two types of timing chains depending on the camshaft gears fitted. Camshaft gears are marked with...



1 | 2 | 3 | 4
footerlogo
popup